Stop Replacing Your Powder Coating Heaters Every Few Months If you want to cut waste in your coating line, you have to start with the gear. When we...

Stop Heating the Air: Why IR Curing is the Only Way to Survive Tight Margins When your margins are razor-thin, every cent counts. The cost of your...

Every time a lamp burns out or a curing cycle goes sideways, your profits take a hit. It’s frustrating. You stop the line, swap the heater,...

Why Most IR Curing Lamps Fail in the Real World We spent some time visiting about 2,000 spray painting shops. Why? Because we wanted to see why so...

Stop Wasting Money Heating Your Ceiling When your margins are thin, you don’t have many knobs to turn. It usually comes down to two things: how...

Stop Guessing Your Cure Times When you’re working with tight margins in a coating shop, time is basically money. Every extra minute a part...

Getting Carbon Fiber to Cure Fast (Without Burning Everything) Curing high-end carbon fiber is a bit of a balancing act. You need enough heat to get...

Fixing the “Zebra Stripe” Problem in Aluminum Powder Coating A buddy of mine runs a pretty well-known aluminum plant, and for about six...

Let’s Talk About 1000W 450mm Quartz Halogen Lamps If you’re doing flash curing, you know the drill. You don’t have minutes to wait...

What 2,000 Shop Floor Audits Taught Us About Curing Lamps I’ve spent a lot of time walking through spray booths and curing lines. After about 2,000...

Fixing the “Cold Spot” Headache in Aluminum Curing A buddy of mine runs a pretty big aluminum plant, and for about six months, they were...

Why You Can’t Trust Your Oven’s Thermostat When you’re coating metal, it’s easy to think you’re just “applying...

Engineering Standards for Industrial Powder Curing Lamps We visited 2,000 powder coating shops to figure out why most curing lamps fail prematurely....

Introduction Let’s cut to the chase. We built this shortwave infrared halogen lamp to be a straight-up, no-nonsense alternative to those pricey...

Cutting Through the Cost Barrier in High-End Curing We’ve been hearing the same question a lot lately: Can a domestic infrared heating lamp...